AUDIOLINE TEL36CLIP Instructions d'exploitation télécharger pdf (Page 20)

Putting the Telephone into Operation

Wall installation

The telephone can also be installed on a wall. Use two screws to insert in the holding slots.

Drill two holes 67 mm apart vertically under each other, insert the screws and allow them to

project 5 mm from the wall. The tabletop support is not required for wall installation. Position

the slots in the telephone base over the screws, insert and slide the telephone down a little.

Caution: Ensure there are no cables or pipes in the wall where the hole is drilled.

In order that the receiver does not fall when placed on−hook, there is a small receiver clip in

the receiver cradle. Use a small screwdriver to turn the clip 180° until a small hook is created

at the top end. You can then place the receiver on−hook.

If the handsfree" function is not activated, you can hook the receiver on the telephone

without interrupting the connection. To do this, there is a hook provided above the

receiver cradle.

Basic settings

When the batteries have been inserted, you are requested to program some basic settings. In-

formation on the methods of illustration and notation used in the operating manual is available

on Page 22.

Setting the language

y or z

e.g.:

[ENGLISH]

, C Select the language and confirm

Setting the contrast

y or z e.g.:

[4]

, C Select the contrast and confirm

Setting the time and date

y or z e.g.:

[15]

, C Set the hour and confirm

y or z e.g.:

[31]

, C Set the minute and confirm

y or z e.g.:

[28]

, C Set the day’s date and confirm

y or z e.g.:

[11]

, C Set the month and confirm

If you want to change these settings at a later date, press and hold the y button

for 4 seconds.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

Pas de commentaire

AUDIOLINE TEL36CLIP Instructions d'exploitation Page 20